5-16 B30 Bus Differential System GE Multilin5.2 PRODUCT SETUP 5 SETTINGS5• In Local Authentication mode, the Observer role does not have a password associated with it. In Remote Authentica-tion mode the Observer role requires a password.• The default password is “ChangeMe1#”.• Once the passwords are set, the Administrator with Supervisor approval can change the role associated password.• In CyberSentry, password encryption is not supported.d) SESSION SETTINGSPATH: SETTINGS PRODUCT SETUP SECURITY SESSION SETTINGSThe following session settings are available.• SESSION LOCKOUT: This setting specifies the number of failed authentications (the default is three and the maxi-mum is 99) before the device blocks subsequent authentication attempts for the lockout period. A value of zero meanslockout is disabled.• SESSION LOCKOUT PERIOD: This setting specifies the period of time in minutes of a lockout period (the default isthree and the maximum is 9999). A value of 0 means that there is no lockout period.e) RESTORE DEFAULTSPATH: SETTINGS PRODUCT SETUP SECURITY RESTORE DEFAULTS• LOAD FACTORY DEFAULTS: This setting is used to reset all the settings, communication and security passwords. AnAdministrator role is used to change this setting and a Supervisor role (if not disabled) approves it.f) SUPERVISORYPATH: SETTINGS PRODUCT SETUP SECURITY SUPERVISORY SESSION SETTINGSSESSION LOCKOUT:3Range: 0 to 99MESSAGE SESSION LOCKOUTPERIOD: 3 minRange: 0 to 9999 minutes RESTORE DEFAULTSLOAD FACTORYDEFAULTS: NoRange: Yes, No SUPERVISORYLOCALAUTHENTICATION:YesRange: Yes, NoMESSAGE BYPASS ACCESS:DisabledRange: Enabled, DisabledMESSAGE LOCK RELAY:DisabledRange: Enabled, DisabledMESSAGE FACTORY SERVICE:MODE: DisabledRange: Enabled, DisabledMESSAGE SELF TESTS See belowMESSAGE SUPERVISOR ROLE:DisabledRange: Enabled, DisabledMESSAGE SERIAL INACTIVITYTIMEOUT: 1 minRange: 1 to 9999 minutes
