GE Multilin B90 Low Impedance Bus Differential System 5-195 SETTINGS 5.2 PRODUCT SETUP5PATH: SETTINGS PRODUCT SETUP COMMUNICATIONS IEC 61850 PROTOCOL GSSE/GOOSE... TRANSMISSIONThe general transmission settings are shown below:PATH: SETTINGS PRODUCT SETUP COMMUNICATIONS IEC 61850... GSSE/GOOSE... TRANSMISSION GENERALThe DEFAULT GSSE/GOOSE UPDATE TIME sets the time between GSSE or GOOSE messages when there are no remote out-put state changes to be sent. When remote output data changes, GSSE or GOOSE messages are sent immediately. Thissetting controls the steady-state heartbeat time interval.The DEFAULT GSSE/GOOSE UPDATE TIME setting is applicable to GSSE, fixed B90 GOOSE, and configurable GOOSE.The GSSE settings are shown below:PATH: SETTINGS PRODUCT SETUP COMMUNICATIONS IEC 61850... GSSE/GOOSE... TRANSMISSION GSEEThese settings are applicable to GSSE only. If the fixed GOOSE function is enabled, GSSE messages are not transmitted.The GSSE ID setting represents the IEC 61850 GSSE application ID name string sent as part of each GSSE message. Thisstring identifies the GSSE message to the receiving device. In B90 releases previous to 5.0x, this name string was repre-sented by the RELAY NAME setting.The fixed GOOSE settings are shown below:PATH: SETTINGS PRODUCT... COMMUNICATIONS IEC 61850... GSSE/GOOSE... TRANSMISSION FIXED GOOSE TRANSMISSION GENERALMESSAGE GSSEMESSAGE FIXED GOOSEMESSAGE CONFIGURABLE GOOSE GENERALDEFAULT GSSE/GOOSEUPDATE TIME: 60 sRange: 1 to 60 s in steps of 1 GSSEGSSE FUNCTION:EnabledRange: Enabled, DisabledMESSAGE GSSE ID:GSSEOutRange: 65-character ASCII stringMESSAGE DESTINATION MAC:000000000000Range: standard MAC address FIXED GOOSEGOOSE FUNCTION:DisabledRange: Enabled, DisabledMESSAGE GOOSE ID:GOOSEOutRange: 65-character ASCII stringMESSAGE DESTINATION MAC:000000000000Range: standard MAC addressMESSAGE GOOSE VLAN PRIORITY:4Range: 0 to 7 in steps of 1MESSAGE GOOSE VLAN ID:0Range: 0 to 4095 in steps of 1MESSAGE GOOSE ETYPE APPID:0Range: 0 to 16383 in steps of 1
