GE Multilin B90 Low Impedance Bus Differential System 4-74 HUMAN INTERFACES 4.2 EXTENDED ENERVISTA UR SETUP FEATURES4Viewing the settings in template mode also modifies the settings tree, showing only the settings categories that containeditable settings. The effect of applying the template to a typical settings tree view is shown below.Figure 4–5: APPLYING TEMPLATES VIA THE VIEW IN TEMPLATE MODE SETTINGS COMMANDUse the following procedure to display settings available for editing and settings locked by the template.1. Select an installed device or a settings file from the tree menu on the left of the EnerVista UR Setup main screen.2. Apply the template by selecting the Template Mode > View All Settings option.3. Enter the template password then click OK to apply the template.Once the template has been applied, users will only be able to edit the settings specified by the template, but all settingswill be shown. The effect of applying the template to the phase time overcurrent settings is shown below.Figure 4–6: APPLYING TEMPLATES VIA THE VIEW ALL SETTINGS COMMANDe) REMOVING THE SETTINGS TEMPLATEIt may be necessary at some point to remove a settings template. Once a template is removed, it cannot be reapplied andit will be necessary to define a new settings template.1. Select an installed device or settings file from the tree menu on the left of the EnerVista UR Setup main screen.2. Select the Template Mode > Remove Settings Template option.3. Enter the template password and click OK to continue.Typical settings tree view without template applied. Typical settings tree view with template applied viathecommand.Template Mode > View In Template Mode842860A1.CDRPhase time overcurrent settings window without template applied. Phase time overcurrent window with template applied viathe command.The template specifies that only the andsettings be available.Template Mode > View All SettingsPickup Curve842859A1.CDR
