GE Multilin C70 Capacitor Bank Protection and Control System 5-795 SETTINGS 5.2 PRODUCT SETUP5b) USER DISPLAY 1(16)PATH: SETTINGS PRODUCT SETUP USER-DEFINABLE DISPLAYS USER DISPLAY 1(16)Any existing system display can be automatically copied into an available user display by selecting the existing display andpressing the ENTER key. The display will then prompt ADD TO USER DISPLAY LIST?. After selecting “Yes”, a message indi-cates that the selected display has been added to the user display list. When this type of entry occurs, the sub-menus areautomatically configured with the proper content – this content may subsequently be edited.This menu is used to enter user-defined text and user-selected Modbus-registered data fields into the particular user dis-play. Each user display consists of two 20-character lines (top and bottom). The tilde (~) character is used to mark the startof a data field – the length of the data field needs to be accounted for. Up to five separate data fields can be entered in auser display – the nth tilde (~) refers to the nth item.A user display may be entered from the faceplate keypad or the EnerVista UR Setup interface (preferred for convenience).The following procedure shows how to enter text characters in the top and bottom lines from the faceplate keypad:1. Select the line to be edited.2. Press the decimal key to enter text edit mode.3. Use either VALUE key to scroll through the characters. A space is selected like a character.4. Press the decimal key to advance the cursor to the next position.5. Repeat step 3 and continue entering characters until the desired text is displayed.6. The HELP key may be pressed at any time for context sensitive help information.7. Press the ENTER key to store the new settings.To enter a numerical value for any of the five items (the decimal form of the selected Modbus address) from the faceplatekeypad, use the number keypad. Use the value of “0” for any items not being used. Use the HELP key at any selected sys-tem display (setting, actual value, or command) which has a Modbus address, to view the hexadecimal form of the Modbusaddress, then manually convert it to decimal form before entering it (EnerVista UR Setup usage conveniently facilitates thisconversion).Use the MENU key to go to the user displays menu to view the user-defined content. The current user displays will show insequence, changing every four seconds. While viewing a user display, press the ENTER key and then select the ‘Yes”option to remove the display from the user display list. Use the MENU key again to exit the user displays menu. USER DISPLAY 1DISP 1 TOP LINE: Range: up to 20 alphanumeric charactersMESSAGE DISP 1 BOTTOM LINE: Range: up to 20 alphanumeric charactersMESSAGE DISP 1 ITEM 10Range: 0 to 65535 in steps of 1MESSAGE DISP 1 ITEM 20Range: 0 to 65535 in steps of 1MESSAGE DISP 1 ITEM 30Range: 0 to 65535 in steps of 1MESSAGE DISP 1 ITEM 40Range: 0 to 65535 in steps of 1MESSAGE DISP 1 ITEM 5:0Range: 0 to 65535 in steps of 1
