GE CDT865SxJ0 Series Technical Service Manual

Contents

GE CDT865SxJ0 Series Technical Service Manual Manual pdf 38 page image

– 38 –Detergent Module Removal1. Remove power to the dishwasher.2. Remove and separate the door.3. Remove the EPS cover. Double back tape is usedto secure and is reusable (when reinstalling theEPS cover, UP must be toward the top of thedoor).4. Remove six 1/4 in. hex head screws.5. The mounting plate removes from inside thedoor.6. The detergent module can now be removedfrom the inner door panel.Detergent DispenserThe detergent module is Solenoid operated, using13.5 VDC (from the UI) to activate the solenoid.Some models have a rinse agent dispenser. Thedispenser holds 3.5 oz. (100 ml) of rinse agent. Undernormal conditions, this will last approximately onemonth.The module receives 13.5 VDC for 1 second toactivate the detergent cup. To activate the rinseaid, the module receives 13.5 VDC for a period of 15seconds.A sensor is used to detect rinse aid level and advisethe consumer when the level is low. The rinse aidsensor is covered on the next page.Diagnosing Detergent Module1. Remove power, then remove and separate thedoor.2. The inner panel may be set into the dishwasherand latched in the closed position.3. Reapply power.4. Place the dishwasher into Service Mode (seeService Mode section in this service guide), thenactivate the detergent test to check for 13.5VDC to the detergent module. Service Modewill provide a 15 second activation time. Theresistance for the detergent module solenoid isű RU² (Continued next page)