Garland MWE2W Installation, Operation & Service Manual
Also see for MWE1S: STEPS FOR PROGRAMMING GRILL RECOVERY CLEANINGProgramming instructionsProgramming Instruction
                                                                                              | |
Contents
|
GARLAND CLAMSHELL GRILLS WITH PRODUCT RECOGNITION INSTALLATION/OPERATION & SERVICE MANUAL - 1&2 PLATENPART #4527466 (12 Aug 2011) Page 35This procedure for placement of meat products on the clamshell grill must be followed exactly. Place patties on the lowergrill plate 2 at a time, from front-to-back, and right-to-left, positioned as shown in the diagrams below. (Each squarerepresents one cooking lane; the area beneath one upper platen.)When cooking is complete, the upper platen will raise automatically. Immediately after the platen raises, season themeat, (if applicable), then remove the patties in the same order they were loaded one at a time. It is important that theunload sequence is identical to the load sequence.10:1 ONLY1 1 1 1 1 1 1 11 11112 2 2 2 2 234443333 332222221NOTE: Patty placement procedure may vary outside of North America. Please consult your local McDonald’s management.OPERATING PROCEDURES (continued)PATTY PLACEMENTLONWORKS INFORMATIONLunch In Auto modeNote: Switching from breakfast to lunch menu items willtake approximately 10 minutes to heat to the appropriatetemperatures.1. Select PM mode. Press and hold the button.2. Select Auto mode. Press and hold the button. Thecontrol will display “PM / AUTOMATIC.”3. Following the lay patterns shown on the followingpage, load product on the grill.4. Press the GREEN or ( GREEN & BLACK) push-button(s) to initiate a cook cycle. The platen will lower,and recognize the product that has been loaded on thegrill.5. Alarm will sound when the cook cycle is complete6. Remove product and clean grill to prepare for nextcook cycle.Transition CookingApproximately 30 minutes before changing to the lunchmenu, perform the following:1. PRESS the button (to display the upper platentemperature).2. Press the button.3. The upper platen indicator will turn on. The upperplaten will heat to 425 degrees F (217 degrees C)the platen will maintain this set temperature unlessanother menu item is selected.To Shutdown GrillTurn Main Power Switch OFF to disable all burners. Forextended periods of shutdown, turn Main Power SwitchOFF, close and disconnect main gas and/or electricalconnections.LonWorks lets manufacturers and integrators create and implement control solutions for customers all over the world.With LonWorks, you can embed intelligence and communications into any device with an electronic heartbeat, and thennetwork these devices so they can work together to sense, monitor, and control. Their embedded intelligence allows themto work without a master controller or PC, and work with enterprise applications and other services.This LonWorks gateway is a “Smart Equipment” networking solution for McDonalds. LonWorks allows us to use existingpower lines to transmit the data rather than the use of Ethernet cabling. The LonWorks gateway will collect informationfrom the grill and transmit it into a computer elsewhere. Capable and authorized users will be able to collect thisinformation and monitor the data from a centralized location. LonWorks enabled or smart equipment will have not onlythe capability of being monitored, but programmed and set up as well. |
Related manuals for Garland MWE1S
manualsdatabase
Your AI-powered manual search engine