GARLAND CLAMSHELL GRILLS WITH PRODUCT RECOGNITION INSTALLATION/OPERATION & SERVICE MANUAL - 1&2 PLATENPART #4527466 (12 Aug 2011) Page 57TO REPLACE THE SHAFT SEALS & CAP O-RINGS (continued)3. Carefully lift platen assembly of shaft as-sembly and place gently on grill plate. Pro-tect grill surface with a piece of cardboardor rag to avoid scratches on grill surface.4. Using a nut driveror a 1/4” ratchet,remove seal capto expose shaftseal underneathseal cap. Supportthe seal cap re-taining bracket onthe underside ofthe back splash.5. Remove old shaftseal, O-ring seal cap& screws o-rings,and install newones.6. Reinstall seal capover shaft andtighten downloosely, the overtight will be at thelast step.7. Attach carriageblocks assemblyto the both sideof the platen armassembly. Ensurethat the Teflonwasher is in placebetween the plat-en arm assemblyand the carriageblock assembly.8. Carefully lift platenarms up and placeback onto shaft as-sembly. Reinstallcarriage blocklocking key intocarriage block,tighten 7/16” bolts.
