3 - DIRECT-TO64 190-00356-00 Rev BShortcutsShortcuts are available when using the direct-tokey, allowing you to bypass the use of the small andlarge right knobs to enter the destination waypoint’sidentifier. A direct-to can be performed from any pagedisplaying a single waypoint identifier (such as theWPT pages for airports and navaids) by simply press-ing direct-to and ENT. For pages that display a listof waypoints (e.g., the nearest airport page), you musthighlight the desired waypoint with the cursor beforepressing the direct-to key.To select an on-screen waypoint (other than themap page) as a direct-to destination:1. If a sngle arport, navad or user waypont sdsplayed on-screen: press direct-to, thenpress ENT twce.2. If a lst of wayponts s dsplayed on-screen:press the small right knob to actvate thecursor, turn the large right knob to hghlghtthe desred waypont, then press direct-tofollowed by ENT twce.Direct-to destinations may also be selected fromthe map page, by panning to the desired destinationlocation and pressing direct-to and ENT (twice).If no airport, navaid or user waypoint exists at thedesired location, a waypoint named “+MAP” willautomatically be created at the location of the pan-ning pointer.To select a direct-to destination from the mappage:1. From the map page, press the small rightknob to dsplay a pannng ponter.2. Turn the small and large right knobs to placethe pannng ponter at the desred destnatonlocaton.3. If the pannng ponter s placed on an exstngarport, navad or user waypont, the waypontname wll be hghlghted. Press direct-to andthen ENT twce to navgate to the waypont.4. If the pannng ponter s placed on an openlocaton, press direct-to and ENT twce tocreate a “MAP” waypont and navgate to t.Direct-to Shortcuts
