Section 4 • Repair ProceduresJanuary 2012Part No. 228901 GS-30 • GS-32 • GS-46 • GS-47 4 - 2713CA and CBCF4RetractExtendCE2CGFRONTOUTRIGGERSY35Y36 13CC and CDCFExtendRetractCE2CGREAROUTRIGGERS4Y33Y34Note: 'alpha-numeric' calloutsrefer to corresponding noteson the electrical schematicNote: 'alpha' callouts referto corresponding notes onthe hydraulic schematicMANIFOLDS5-7Outrigger Cylinder Manifold Components -GS-3232The front outrigger cylinders are located behind the inspection doors at the battery side and at the groundcontrol side of the machine. The rear outrigger cylinders are located inside the outrigger enclosures at therear of the machine.How to Install a Valve Cartridge1 Dip the cartridge in clean oil to lube the O-rings.2 Screw the cartridge in by hand until the topO-ring is met, then torque to specification.3 If required, install the valve coil(s) onto thevalve stem. Install the coil nut onto the valvestem and torque to specification.Index SchematicNo. Description Item Function Torque— Coil nut (item CA, CB, CC, CD) ............................................................................................ 4-5 ft-lbs / 5-7 Nm1 Solenoid valve, 2 position 2 way ............... CA, CB, CC, CD . Outrigger extend/retract ......... 25 ft-lbs / 34 Nm2 Orifice - plug,0.037 inch / 0.94 mm ................................. CE ...................... Outrigger retract3 Check valve, pilot operated ....................... CF ...................... Retract flow control ............ 20 ft-lbs / 27.1 Nm4 Pressure Transducer ................................. CG ...................... Outrigger auto level ............. 16 ft-lbs / 21.7 Nm
