Section 4 • Repair ProceduresJanuary 2012Part No. 228901 GS-30 • GS-32 • GS-46 • GS-47 4 - 376-3Steer BellcrankHow to Remove the SteerBellcrank1 Remove the steer cylinder. See 6-2,How toRemove the Steer Cylinder.2 Remove the retaining fasteners from the steerlinks at each end of the bellcrank.Note: While removing the retaining fasteners, takenote of the quantity and location of the spacersbetween the bellcrank and the steer links.3 Center a lifting jack under the drive chassis atthe steer end.4 Raise the machine approximately14 inches / 36 cm. Place blocks under thechassis for support.Crushing hazard. The chassiscould fall if not properly supported.5 Turn the yokes to the side so the bellcrank canbe removed.6 Remove the bellcrank from the machine.Note: While removing the bellcrank from themachine, take note of the quantity and location ofthe spacers between the bellcrank and the steerlinks.Note: Before re-installing the steer bellcrank ontothe machine, apply a small amount of Loctite ontothe threads of the fasteners. Torque the fastenersto 31 ft-lbs / 42 Nm.
