MOVING A DISABLED MACHINETow the machine only when no alternative is possible,since this operation may result in serious damage tothe transmission. When possible, repair the machineon site.When the machine shall absolutely be towed: Unlock the parking brake. Tow the machine for short distances and at a lowspeed only (less than 5 km/h). Use a rigid drawbar. Select the two-wheel steer. Set the forward/back speed lever to neutralposition. Put the gearbox lever to neutral (see below) Raise the front wheels of the machine. When possible, start the engine and use thehydraulic drive and the braking system.Transporting The MachineUnlocking the negative brake (only for GTH-4017EX - GTH-4514 EX)To unlock the negative brake of a faulty machine,use the four screws 31 on the two sides of the frontdifferential casing as follows:Loosen the four counter-nuts fixing screws 31,then move the nuts backwards by approx. 8mm.Tighten screws 31 so as to fasten them onto thepressure plate.Using a wrench, tighten the screws 31 in analternate sequence by 1/4 turn a time so as tocompress the Belleville washers and disengagethe braking disks. Tighten max. by one turn.After the manual release, adjust screws 31 to ob-tain a jut of 30 ± 0.5 mm in relation to the arm.LSetting the gear lever in neutralNOTICEDo not tow the machine without setting the me-chanical gear lever to neutral position.To set the gear lever to neutral: Disconnect the cylinder hoses A and B. Pry the cursor of the gearbox lever C to neutralposition (L = 20 mm). Riconnect the cylinder hoses A and B.Part No. 57.0009.0454 GTH-4013EX - GTH-4514EX - GTH-4017EX 61Operator’s ManualSecond Edition - Second PrintingCourtesy of Crane.Market