Genie GTH 4013 EX Operator's Manual

Contents

MaintenanceADJUSTING THE SLIDING PADS OF THE BOOMSECTIONSAny boom section is fitted with adjustable padslocated on the four sides of the profile. These padsare secured to both fixed and mobile part of everysection.All pads can be adjusted by the special shims suppliedby TEREXLIFT upon demand.Adjusting the pads: Remove or loosen the screws fixing the pads inrelation to type of shims used (with or withoutslots). Fit the necessary amount of shims. If the residual thickness of the pad is insufficientor near the maximum wearing limit, renew thepad. Tighten the screws fixing the pads at therecommended torque (see below). Use adynamometric wrench.Tightening torques of the pad screws in relationto the screw diameterScrews M10 Nm 30Screws M14 Nm 50Tightening torques higher than those recom-mended can cause the break of the pad or of thelocking threaded bush.CAU T I ONPads must compulsorily be replaced if theresidual thickness of the plastic layer withrespect to the iron bush fixing the block is equalor inferior to 1 mm.SERVICE INTERVALRunning-in __________________________ NoneOrdinary __________________ When necessaryMinimum 1 mmMax. wearing thicknessOperator’s Manual84 GTH-4013EX - GTH-4514EX - GTH-4017EX Part No. 57.0009.0454Second Edition - Second PrintingCourtesy of Crane.Market