Optional Attachments900 KG EXTENSION JIB(code 59.0802.3008 _ Mechanical Version) ApplicationQuick-coupling fitted attachment for maintenanceinterventions at high working heights.SafetyStrictly obey the general safety precautions givenin section “Safety”.Never lift wrongly slung loads.Avoid abrupt acceleration or deceleration.Avoid load oscillations, and especially do not movethe load from the vertical pull line.Do not pull crosswise and do not tow.Operation Couple the jib and hold it in position by meansof the attachment locking system (mechanicalor hydraulic). Set the attachment supports in working position1, using the dedicated pins A. Lift the attachment support 3 locking it in workingposition by means of the dedicated pin B. All loads must be bridled with special textileslings or chains in compliance with all pertinentregulations. To handle the load, raise and rotate thetelescopic boom of the handler. To remove the attachment, set the supports inresting position 2, lower the attachment support3 locking it in resting position by means of thededicated pin B, carefully tilt the attachmentforward, lower the boom resting the attachmenton the ground, then retract the boom.MaintenanceVisually check the jib for damage before using it.Check the safety catch is in good working order.Daily grease the joints using the greasing gun.Make sure this attachment can be used in thedestination country of the machine.Application must be submitted directly by theuser.DANGER Do not allow suspended loads to oscillate.Do not drag loads when they are hooked up. A suspended load has a dynamic, andtherefore an unpredictable effect on machinestability, operate with caution.For the use of this attachment, read the specificmanual.TECHNICAL DATAWidth 1190 mmHeight in resting position 2 1220 mmLength 4450 mmHeight in working position 1 980 mmWeight 245 kgPayload 900 kgCoG 1340 mmOperator’s ManualFirst Edition - Second PrintingPart No. 57.0009.0540 GTH-4013 SX - GTH-4017 SX - GTH-4013 EX - GTH-4017 EX 145Courtesy of Crane.Market
