Operation Manual – MSTPH3C S3100-52P Ethernet Switch Chapter 1 MSTP Configuration1-33 system-view[Sysname] stp interface Ethernet 1/0/1 edged-port enable2) Configure Ethernet 1/0/1 as an edge port in Ethernet port view system-view[Sysname] interface Ethernet 1/0/1[Sysname-Ethernet1/0/1] stp edged-port enable1.3.13 Specifying Whether the Link Connected to a Port Is Point-to-pointLinkA point-to-point link directly connects two switches. If the roles of the two ports at thetwo ends of a point-to-point link meet certain criteria, the two ports can turn to theforwarding state rapidly by exchanging synchronization packets, thus reducing theforward delay.You can determine whether or not the link connected to a port is a point-to-point link inone of the following two ways.I. Specify whether the link connected to a port is point-to-point link in systemviewFollow these steps to specify whether the link connected to a port is point-to-point link insystem view:To do... Use the command... RemarksEnter system view system-view —Specify whether the linkconnected to a port ispoint-to-point linkstp interface interface-listpoint-to-point{ force-true | force-false |auto }RequiredThe auto keyword isadopted by default.II. Specify whether the link connected to a port is point-to-point link inEthernet port viewFollow these steps to specify whether the link connected to a port is point-to-point link inEthernet port view:To do... Use the command... RemarksEnter system view system-view —Enter Ethernet port view interface interface-typeinterface-number —Specify whether the linkconnected to a port is apoint-to-point linkstp point-to-point{ force-true | force-false |auto }RequiredThe auto keyword isadopted by default.