Operation Manual – LoginH3C S3100-52P Ethernet switch Chapter 2 Logging In Through the Console Port2-9III. Configuration procedure# Enter system view. system-view# Enter AUX user interface view.[Sysname] user-interface aux 0# Specify not to authenticate users logging in through the console port.[Sysname-ui-aux0] authentication-mode none# Specify commands of level 2 are available to users logging in to the AUX userinterface.[Sysname-ui-aux0] user privilege level 2# Set the baud rate of the console port to 19,200 bps.[Sysname-ui-aux0] speed 19200# Set the maximum number of lines the screen can contain to 30.[Sysname-ui-aux0] screen-length 30# Set the maximum number of commands the history command buffer can store to 20.[Sysname-ui-aux0] history-command max-size 20# Set the timeout time of the AUX user interface to 6 minutes.[Sysname-ui-aux0] idle-timeout 6After the above configuration, you need to modify the configuration of the terminalemulation utility running on the PC accordingly in the dialog box shown in Figure 2-4 tolog in to the switch successfully.2.5 Console Port Login Configuration with AuthenticationMode Being Password2.5.1 Configuration ProcedureFollow these steps to configure console port login with the authentication mode beingpassword:To do… Use the command… RemarksEnter system view system-view —Enter AUX userinterface view user-interface aux 0 —
