Operation Manual – System Maintenance and DebuggingH3C S3100-52P Ethernet SwitchChapter 1 Boot ROM and Host SoftwareLoading1-14II. Loading Procedure Using FTP ServerAs shown in Figure 1-9, the switch is used as the FTP server. You can telnet to theswitch, and then execute the FTP commands to upload the Boot ROM switch.btm to theswitch.1) Loading the Boot ROMFigure 1-9 Remote loading using FTP serverStep 1: As shown in Figure 1-9, connect the switch through an Ethernet port to the PC(whose IP address is 10.1.1.1)Step 2: Configure the IP address of VLAN-interface 1 on the switch to 192.168.0.28,and subnet mask to 255.255.255.0.Note:You can configure the IP address for any VLAN on the switch for FTP transmission.However, before configuring the IP address for a VLAN interface, you have to makesure whether the IP addresses of this VLAN and PC are routable. system-viewSystem View: return to User View with Ctrl+Z.[Sysname] interface Vlan-interface 1[Sysname-Vlan-interface1] ip address 192.168.0.28 255.255.255.0Step 3: Enable FTP service on the switch, and configure the FTP user name to test andpassword to pass.[Sysname-Vlan-interface1] quit[Sysname] ftp server enable[Sysname] local-user testNew local user added.[Sysname-luser-test] password simple pass[Sysname-luser-test] service-type ftpStep 4: Enable FTP client software on the PC. Refer to Figure 1-10 for the commandline interface in Windows operating system.
