Operation Manual – QoS-QoS ProfileH3C S3100-52P Ethernet Switch Chapter 1 QoS Configuration1-24To do… Use the command… RemarksConfigure line rateline-rate { inbound |outbound } target-rate[ burst-bucketburst-bucket-size ]RequiredSpecify a committedinformation rate (CIR) for thetarget-rate argument, andspecify a committed bustsize (CBS) for theburst-bucket-size argument.By default, line rate isdisabled.III. Configuration examplez Configure line rate for outbound packets on Ethernet 1/0/1.z The rate limit is 1,024 KbpsConfiguration procedure: system-view[Sysname] interface Ethernet1/0/1[Sysname-Ethernet1/0/1] line-rate outbound 10241.4.7 Configuring Traffic RedirectingRefer to section Traffic Redirecting for information about traffic redirecting.I. Configuration prerequisitesz The ACL rules used for traffic classification have been defined. Refer to the ACLmodule of this manual for information about defining ACL rules.z The traffic redirecting destination has been determined.z The ports that need this configuration have been determined.II. Configuration procedureFollow these steps to configure traffic redirecting:To do… Use the command… RemarksEnter system view system-view —Enter Ethernet port view interface interface-typeinterface-number —Configure trafficredirectingtraffic-redirect { inbound |outbound } acl-rule { cpu |{ interface interface-typeinterface-number |link-aggregation-groupagg-id } [ untagged ] }RequiredBy default, trafficredirecting is notconfigured.
