Operation Manual – LoginH3C S3100-52P Ethernet switchChapter 5 Logging In Through the Web-basedNetwork Management System5-22) Configure the user name and the password on the switch for the Web networkmanagement user to log in.# Create a Web user account, setting both the user name and the password to adminand the user level to 3. system-view[Sysname] local-user admin[Sysname-luser-admin] service-type telnet level 3[Sysname-luser-admin] password simple admin3) Establish an HTTP connection between your PC and the switch, as shown inFigure 5-1.Figure 5-1 Establish an HTTP connection between your PC and the switch4) Log in to the switch through IE. Launch IE on the Web-based networkmanagement terminal (your PC) and enter the IP address of the managementVLAN interface of the switch in the address bar. (Make sure the route between theWeb-based network management terminal and the switch is available.)5) When the login authentication interface (as shown in Figure 5-2) appears, enterthe user name and the password configured in step 2 and click to bring upthe main page of the Web-based network management system.Figure 5-2 The login page of the Web-based network management system5.3 Configuring the Login Banner5.3.1 Configuration ProcedureIf a login banner is configured with the header command, when a user logs in throughWeb, the banner page is displayed before the user login authentication page. Thecontents of the banner page are the login banner information configured with theheader command. Then, by clicking on the banner page, the user can
