249Field Descriptionmismatch port configuration.Transceiver type not supported by porthardware The port does not support this type of transceiver module.Examples# Display the alarms present on the transceiver module in interface Ten-GigabitEthernet 1/0/1. display transceiver alarm interface ten-gigabitethernet 1/0/1Ten-GigabitEthernet1/0/1 transceiver current alarm information:RX loss of signalRX power lowTable 45 Command outputField Descriptiontransceiver current alarm information Alarms present on the transceiver module.RX loss of signal Received signals are lost.RX power low Received power is low.Temp high Temperature is high.display transceiver diagnosisUse display transceiver diagnosis to display the current values of the digital diagnosis parameterson transceiver modules.Syntaxdisplay transceiver diagnosis interface [ interface-type interface-number ]ViewsAny viewPredefined user rolesnetwork-adminnetwork-operatorParametersinterface [ interface-type interface-number ]: Specifies an interface by its type and number. If nointerface is specified, this command displays the current values of the digital diagnosis parameterson every transceiver module.Usage guidelinesThis command cannot display information about some transceiver modules.Examples# Display the current values of the digital diagnosis parameters on the transceiver module ininterface Ten-GigabitEthernet 1/0/2. display transceiver diagnosis interface ten-gigabitethernet 1/0/2Ten-GigabitEthernet1/0/2 transceiver diagnostic information:Current diagnostic parameters:Temp.(°C) Voltage(V) Bias(mA) RX power(dBm) TX power(dBm)43 3.31 6.23 -6.50 -2.15
