3 - 14 Quick Check® 600/800 Series User’s Guide• When you have the AutoPrint/Store feature turned on, but no printer isconnected to your verifier, or your printer is connected, but is turned off, yourscan results are automatically stored in the verifier’s memory.• When you have the AutoPrint/Store feature turned off, after each scan youneed to instruct the verifier to print your data (if a printer is connected andturned on) or to store your data (if a printer is not connected or is turned off).The default is setting for AutoPrint/Store is ON.Scan ProfileThe Quick Check 600/800 Verifier allows you to print the scan profile which is arecord of the reflectance values seen by a scanner as it moves across a symbol.The scan profile is the basis of ISO/IEC evaluation and is usually presented in agraphic form.• When you use the AutoPrint/Store feature with Profile, you can choose tohave the scan results stored so you can later print a graphic scan profile on aprintout.• When you use AutoPrint/Store without Profile, the raw data is not stored.♦ To change the output options:1. Display the menu that begins with Print Results (press POWER and thenSELECT).2. Set the cursor on the asterisk next to Change Settings and then pressSELECT. A menu that begins with Specifications appears.3. Set the cursor on the asterisk next to Output Options and then pressSELECT. A menu that contains Display Options and Printout Optionsappears.4. To change the display options:• To change the display options, set the cursor on the asterisk next toDisplay Options and then press SELECT. A menu with four displayoptions selections appears.• To change the data displayed in the upper (3rd line) or the lower (4thline) parameter result line, set the cursor on the asterisk next toUpperLine and then press SELECT or →. The cursor moves to theright of the term. Press ↑ and ↓ until the name of the data that youwant to show up on the parameter result line appears. To save theselection, press SELECT or ←. The cursor moves back to the asterisknext to the term.• To change the error override feature, set the cursor on the asterisknext to Error Override and then press SELECT or → until the settingyou want, YES (Y) or NO (N), appears.• To change what the LEDs indicate, set the cursor on the asterisk nextto LEDs and then press SELECT or → until the setting you want, P/FCriteria or Bar Growth!, appears.• Press POWER to return to the menu that contains Display Optionsand Printout Options.