Quick Check® 600/800 Series User’s Guide 4 - 7Note: If you set the Test Criteria Passing parameter to an ISO/IEC grade andyou set the #Scans/Symbol parameter to 1, the scan grade is the sameas the ISO/IEC symbol grade.• The first line of the symbol grade display provides the symbol orapplication name, the same as the first line of the scan grade display.• The second line of this display indicates this data is a final symbolgrade, that is, it is an average of the scan grades you have obtained.• The third line provides a variety of information. The first of the threeterms refers to the current average grade the symbol received. Thesubsequent terms, for example 06/660, refer to the wand aperture andthe wavelength. These values are used to determine the symbolgrade. Refer to "If the unit was set to use the database feature beforebeing turned off, the bottom line shows the term DATABASE." onpage 1-9 for additional information.• The last line lets you check your status in relation to thesymbol grade. The first value in this line tells you how many scangrades were used to calculate the displayed symbol grade. Thesecond value tells you the number of scan grades required tocalculate the final symbol grade.• The large letter or number on the right of the display is the symbolgrade. The verifier can display the symbol grade either as letter (A, B,C, D, F) or as a number (4, 3, 2, 1, 0), depending on how you set theTest Criteria Grades parameter.5. To obtain the final symbol grade, you must satisfy the #Scans/Symbolsetting. Repeat steps 2 through 4, scanning the same bar symbol atdifferent paths within the symbol.• When you satisfy the #Scans/Symbol setting, the finalsymbol grade display appears.To review the scan grade display, press ↓. Press ↑ to return to thefinal symbol grade display.The types of data provided in the final symbol grade display are thesame as those in the symbol grade display.♦ To review data from the last scan:1. If the Quick Check Verifier is turned off, turn it on.The opening display appears.2. Press ←.The results from the last scan appear.LED DisplayThe light-emitting diodes (LEDs) can indicate either bar growth and shrinkagebased on traditional test criteria or a pass/fail grade result based on ISO/IECgrade criteria. You set the type of test criteria. Refer to "Changing the TestCriteria" on page 3-8 for additional information.