Hardi MASTER TWIN STREAM Instruction Book

GB 05 03 01Sprayer setupTTTTTrrrrransmission shaftansmission shaftansmission shaftansmission shaftansmission shaftOperOperOperOperOperaaaaator saftor saftor saftor saftor safetyetyetyetyetyTo avoid accidents and personal injuries, note thefollowing recommended precautions and safe operationpractices.1. Always STOP ENGINE before attaching the transmis-sion shaft to tractor P.T.O. - most tractor P.T.O. shaftscan be rotated by hand to facilitate spline alignment,when engine is stopped.2. When attaching the shaft, make sure that the snaplock is FULLY ENGAGED - push and pull shaft until itlocks.WARNING! ROTATING TRANSMISSIONSHAFTS WITHOUT PROTECTION GUARDSARE FATAL.3. Always keep protection guards and chains intact andmake sure that it covers all rotating parts, includingCV-joints at each end of the shaft. Do not use withoutprotection guard.4. Do not touch or stand on the transmission shaft whenit is rotating - safety distance: 1.5 meter.5. Prevent protection guards from rotating by attachingthe chains allowing sufficient slack for turns.6. Make sure that protection guards around tractorP.T.O. and implement shaft are intact.7. Always STOP ENGINE and remove the ignition keybefore carrying out maintenance or repairs to thetransmission shaft or implement.InstallaInstallaInstallaInstallaInstallation oftion oftion oftion oftion of trtrtrtrtransmission shaftansmission shaftansmission shaftansmission shaftansmission shaftFirst installation of the transmission shaft is done in thefollowing way:1. Attach sprayer to tractor and set sprayer height in theposition with shortest distance between the tractorand sprayer pump P.T.O. shafts.2. Stop engine and remove ignition key.3. If transmission shaft must be shortened, the shaft ispulled apart.Fit the two shaft parts at tractor and sprayer pumpand measure how much it is necessary to shorten theshaft.Mark the protection guards.NOTE! The shaft must always have a minimum overlap.The size of this overlap depends on the pump model:Pump with 6 splines/540 r.p.m.The shaft must always have an overlap (A) of minimum1/3 of the length.Pump with 21 splines/1000 r.p.m.The shaft must always have an overlap (A) of minimum2/3 of the length.4. The two parts are shortened equally. Use a saw, andfile the profiles afterwards to remove burrs.5. Grease the profiles and assemble male and femaleparts again.6. Fit the shaft to tractor P.T.O. and sprayer pump shaft.NOTE! Female part marked with a tractor towardstractor!T259-0004T259-0005 T259-0007T259-0011T259-0011(A)(A)(A)(A)(A)(A)(A)(A)(A)(A)