Hardi MASTER TWIN STREAM Instruction Book

GB 08 00 MAOperation - liquid systemFFFFFilling ofilling ofilling ofilling ofilling of ccccchemicalshemicalshemicalshemicalshemicalsChemicals can be filled in the tank in two ways:1. Through tank lid.2. HARDI FILLER chemical filling device.WARNING! Always wear correct protectiveclothing before handling chemicals!1. F1. F1. F1. F1. Filling thrilling thrilling thrilling thrilling through tank lidough tank lidough tank lidough tank lidough tank lidThe chemicals are filled through the tank lid - Noteinstructions on the chemical container!WARNING! Be careful not to slip or splashchemicals when carrying chemicals up to thetank lid!1. Make sure the EVC is switched off.2. Set the MANIFOLD valves to correct position. Blackvalve “Suction from main tank”, green valve towards“Agitation”3. Engage the pump and set P.T.O. revolutions to 540r/min.4. Add the chemicals through the main tank hole.5. When the spray liquid is well mixed, turn handle onthe Pressure Manifold towards “Spraying” position.Keep P.T.O. engaged so the spray liquid is continu-ously agitated until it has been sprayed on the crop.2. HARDI FILLER c2. HARDI FILLER c2. HARDI FILLER c2. HARDI FILLER c2. HARDI FILLER chemical inductorhemical inductorhemical inductorhemical inductorhemical inductor(optional equipment)(optional equipment)(optional equipment)(optional equipment)(optional equipment)HARDI FILLER (G)Filling of Liquid chemicals1. Fill the main tank at least 1 / 3 with water (unlesssomething else is stated on the chemical containerlabel). See section “Filling of water”.2. Turn the handle at the Suction Manifold towards“Main tank”. Turn blue valve towards “Agitation andNOTE! The scale in the hopper can only be used if thesprayer is parked at level ground! It is recommended touse a measuring jug for best accuracy.7. Open the bottom valve A and the chemical is trans-ferred to the main tank.8. If the chemical container is empty it can be rinsed bythe container rinsing device (if fitted). Place thecontainer over the multi-hole nozzle and press thelever B.WARNING! Do not press lever B unless themulti-hole nozzle is covered by a container toavoid spray liquid hitting the operator.IMPORTANT! Rinsing device uses spray liquid to rinsecontainers for concentrated chemicals. Always rinse thechemical containers with clean water several times untilthey are clean before disposal.9. Engage the hopper rinsing device by opening valve C.10. Close valve C again when the hopper is rinsed.IMPORTANT! The hopper rinsing device is using sprayliquid for rinsing the hopper for concentrated chemical!The FILLER must always be cleaned together with therest of the sprayer when the spray job is done.11. Close valve A and the FILLER lid again.12. When the spray liquid is well mixed, turn handle onthe Pressure Manifold towards “Spraying” position.Keep P.T.O. engaged so the spray liquid is continu-ously agitated until it has been sprayed on the crop.T102-0016Ggreen valve towards “HARDI FILLER”. Close remain-ing valves.3. Check that bottom valve A at the FILLER is closed.4. Engage the pump and set P.T.O. speed at 540 r/min.5. Open FILLER lid.6. Measure the correct quantity of chemical and fill it intothe hopper.