Harman Kardon AVR80 Owner's Manual

Also see for AVR80: Owner's manual Technical manual

Remote Control Functions9ENGLISHn P-Scan: Press this button toautomatically scan through thestations preset into the tuner memory.Press the button again to end thescan when the tuner stops at thedesired station.o Memo: The memo button is usedto enter stations to the tuner’s presetmemory in either the manual orautomatic modes. It is also used in theprocess of clearing the memory.p Delay: This button controls theamount of sound delay to the rear(surround) channels. Press it toincrease the delay in the steps shownin the main Information Display oron-screen graphics.q Menu Controls: These buttonscontrol the action of the cursor or theselection of menu items when thereceiver is being configured using thesetup menus.r Select: This button chooses amenu and enters settings to thereceiver’s memory during systemconfiguration.s Screen Display: Press thisbutton to activate the on screen menusystem.t Panel Display: Press this buttonto turn off all displays and indicators inthe Information Display except for asmall D I S P indication in the lowerright corner of the display ¤ Press thebutton again to turn the display backon. Note that the display will brieflyilluminate when a command is sent tothe unit from the front panel or remote,even though the display is turned off.u Test Noise: Press this button tobegin calibration of the output level foreach channel. A test signal willimmediately be heard from the leftfront speaker and the TEST indicator™ will flash.v Speaker Select: When settingthe system output levels, this buttonselects the speaker position beingadjusted. Press it once to advance tothe next speaker after each position isadjusted.w Level Adjust: When setting thesystem output levels, press thesebuttons in increase or decrease theoutput level.x Sending LED: This indicatorshould flash any time a button ispressed to confirm that a command isbeing sent to the receiver or anotherunit. If the light is dim or does notilluminate when a button is pressed thebatteries in the remote should bereplaced.y Learn LED: This indicator willilluminate when a button on theremote is being programmed withsignals from another remote duringthe “learning” mode. The light will goout when the signal is received andmemorized.z RDS PTY: Press this button toview the Programme Type informationfor stations transmitting RDS data.This button is also used for PTY AutoSearch functions.` RDS AF: This button initiates asearch of alternate frequencies to findan eventually stronger signal for thestation type currently selected.AVR80 manual 11/01/98 13:01 Side 9