Harman Kardon AVR80 Owner's Manual

Also see for AVR80: Owner's manual Technical manual

Remote Control Programming & Operation14ENGLISHAnother group of keys may only beprogrammed with one remote code. Thecode contained in these keys remains thesame regardless of the source selection.WARNING: These keys transmit codesthat are vital to the operation of theproduct. It is not recommended that theybe programmed with alternative codes, asit may then be impossible to operatecertain functions of the receiver.THXAuxCursor Up ⁄Pro LogicDelayCursor Down ¤Dolby 3 StereoMemoCursor Right ›MovieScreen DisplayCursor Left ‹MatrixPanel DisplaySelectHallSpeakerMain Volume Up ⁄StereoTest NoiseMain Volume Down ¤MonoAdjustMuteRDS PTYRDS AFTo program the remote, you need theremote of the device, whose functionsshall be programmed. Note that it is notnecessary to program all keys, only thosethat are required to operate the subjectdevice. Keys not programmed will retainthe codes preprogrammed at the factory.1. Slide Use/Learn a switch at the topleft corner of the remote to the right sothat it is next to Learn.2. If one of the multi-function buttons isbeing programmed press the sourcebutton (i.e. CD, VCR, etc.) you wish tohave this function associated with. If youare programming a single function key,proceed to the next step.3. Press the button on the remote that isto be programmed. Note that theLearning y LED will illuminate.4. Place the remote head to head with theremote control whose function is beinglearned. The two remotes should be nomore than 8 inches apart.5. Press and hold the button on thetransmitting remote corresponding to thefunction to be memorized until theLearning LED starts to blink. When theLED goes out, release the button on thetransmitting remote. The function codehas been successfully captured.NOTE: If both LEDs flash during aprogramming operation, it indicates thatthe remote’s memory is full or that theremote codes from the transmittingremote are not compatible with the unit’ssignal format.6. Continue to program any additionalremote commands required using steps 2through 5. When you have finishedprogramming the remote, slide theUse/Learn switch to the left so that it isin the Use position.Clearing the Remote MemoryIn normal operation, codes for a newdevice may be programmed “over” thecodes that have been previouslyprogrammed into the remote. It is alsopossible to clear the memory forindividual keys, or for the entire remote.When a memory position is cleared, theremote will return to the original factorypreset command.To clear the memory for a specificindividual key location, put theUse/Learn switch in the Learnposition. Press the Main Power Off bbutton and the button to be cleared at thesame time. Both the Sending andLearning indicators will lightmomentarily. When the lights go out, thememory has been cleared of the userprogrammed code and returned to thefactory preset. Return the Use/Learna switch to the Use position when youare finished.To clear the remote’s entire memoryand return all keys to their factory presetcommands first put the Use/Learn aswitch in the Learn position. Then pressthe Main Power On button b andconfirm that the Learning indicator yhas illuminated. While continuing topress the Power On button, press andhold the Power Off b button until theLearn indicator goes off for about 3seconds. It will then blink twice. Thenrelease the two buttons. This indicatesthat the memory has been cleared of anyuser programmed commands and thatthe original commands have beenrestored. Slide the Use/Learn switchback to the Use a position to returnthe remote to normal operation.AVR80 manual 11/01/98 13:01 Side 14