9. If you are installing a 5.2-inch drive in bay 2, slide the drive into the bay. If youare installing a 3.5-inch drive in bay 2, you must attach the 5.2-inch.conversion kit to the 3.5-inch drive.Note: An optional diskette drive can be installed in bay 3.10. Connect one end of the applicable signal cable into the rear of the drive andmake sure that the other end of this cable is connected into the applicableSATA connector on the system board.11. Route the signal cable so that it does not block the airflow to the rear of thedrives or over the microprocessor and dual inline memory modules (DIMMs).12. If you have another drive to install or remove, do so now.13. Connect the power cable to the rear of the drive. The connectors are keyedand can be inserted only one way.If you have other devices to install or remove, do so now; otherwise, go to“Completing the installation” on page 52.Installing a tape driveTo install a tape drive, complete the following steps:1. Read the safety information that begins on page v and “Installation guidelines”on page 20.2. Turn off the server and peripheral devices, and disconnect the power cordsand all external cables.3. Remove the side cover (see “Removing the side cover” on page 24).4. Remove the two-piece bezel (see “Removing the two-piece bezel” on page25).5. Use a screwdriver to pry the filler panel and EMC shield away from the server.6. Touch the static-protective package that contains the drive to any unpaintedmetal surface on the server; then, remove the drive from the package andplace it on a static-protective surface.7. Set any jumpers or switches on the drive according to the documentation thatcomes with the drive.34 System x3200 M2 Types 4367 and 4368: User’s Guide
