v When you start the server for the first time after you install a Remote SupervisorAdapter II SlimLine, the startup process will take several minutes longer than atypical startup.v The server scans PCI Express x8 slot 1, PCI Express x4 slot 2, PCI-X slot 3, andPCI slots 4 and 5 to assign system resources. Then, the server starts the PCIdevices in the following order, if you have not changed the default startupsequence: PCI Express x8 slot 1, PCI Express x4 slot 2, PCI-X slot 3, PCI slot 4,and PCI slot 5.v For a list of supported optional devices for the server, see http://www.ibm.com/servers/eserver/serverproven/compat/us/.Attention: Static electricity that is released to internal server components whenthe server is powered-on might cause the server to stop, which might result in theloss of data. To avoid this potential problem, always use an electrostatic-dischargewrist strap or other grounding system when you work inside the server with thepower on.See “System-board optional-device connectors” on page 18 for the locations of theexpansion slots and the Remote Supervisor Adapter II SlimLine connector.To install an adapter, complete the following steps:1. Read the safety information that begins on page v and “Installation guidelines”on page 20.2. Turn off the server and peripheral devices and disconnect all external cablesand power cords; then, remove the side cover. See “Removing the side cover”on page 24.3. Follow the cabling instructions, if any, that come with the adapter. Route theadapter cables before you install the adapter.4. Follow the instructions that come with the adapter to set jumpers or switches, ifany.5. Rotate the rear adapter-retention bracket to the open position and remove itfrom the server.42 System x3200 M2 Types 4367 and 4368: User’s Guide
