Table 12. Cabling tasks to enable remote access to the Remote Supervisor Adapter IISlimLineUser interface to Remote SupervisorAdapter II SlimLineConnection to Remote SupervisorAdapter II SlimLineASM Web-based interface using HTTP LAN using the Ethernet connectorText-based interface using TelnetTo connect the Ethernet cables, complete the following steps:1. Connect one end of a Category 3 or Category 5 Ethernet cable to the dedicatedEthernet connector for the Remote Supervisor Adapter II SlimLine. Connect theother end of the cable to the network. The following illustration shows thelocations of the Ethernet connectors.2. To make sure that the network connection is working, check the Ethernet LEDs.The following illustration shows the locations of the LEDs.Serial 2 (Com2)Serial 1 (Com1)VideoUSB 3 and 4USB 1 and 2RemoteSupervisorAdapter IISlimLine(Ethernet)EthernetconnectorParallelPower cordAC power LEDDC power LEDEthernet transmit/receive activity LED(amber)Ethernet linkstatus LED(green)Installing the Remote Supervisor Adapter II SlimLine firmwareThe software and firmware files that you need are contained in one system servicepackage installation kit. The kit contains the following files:v Software and firmware installation instructionsv BIOS code update with support for the Remote Supervisor Adapter II SlimLinev Diagnostics code updatev Remote Supervisor Adapter II SlimLine device driversv Remote Supervisor Adapter II SlimLine firmware updatev Integrated service processor firmware updatev Video device driverv Firmware-update utility programTo download and install the software and firmware, complete the following steps.72 System x3200 M2 Types 4367 and 4368: User’s Guide
