IBM 8686 - Eserver xSeries 360 Hardware Maintenance Manual

Also see for 360: Specifications Operating guide User guide Hardware Maintenance Manual Manual

Contents

12. Continue with “Installing Advanced System Management device drivers.”Installing Advanced System Management device driversYou must install the ASM device drivers for the server. The device drivers enablecommunication between the Remote Supervisor Adapter and the server in which itis installed. You can obtain the most current device drivers from the World WideWeb at http://www.ibm.com/pc/support/.The following sections describe the procedure for installing the ASM device driversfor the server, depending on your operating system.Notes:1. If you are installing device drivers manually, note the following requirements:v Make sure that the operating system is installed on the server before youinstall the ASM device drivers. For information about installing the operatingsystem, see the documentation that comes with the operating system.v Before installing the ASM device drivers for the Remote Supervisor Adapter,stop any system-management application.2. If you are using ServerGuide to install device drivers and your operating systemis either Microsoft Windows NT or Windows 2000, ServerGuide installs the ASMdevice drivers automatically.v Windows 2000: Continue with “Installing Windows 2000 ASM device drivers”v Windows NT: Go to “Installing Windows NT ASM device drivers” on page 48v Novell NetWare: Go to “Installing Novell NetWare ASM device drivers” on page49v SCO UnixWare: Go to “Installing SCO UnixWare ASM device drivers” on page 49After you install the ASM device drivers, go to “Configuring the remote controlpassword” on page 50 to set the remote control password.Installing Windows 2000 ASM device drivers: To install the ASM device driversfor Windows 2000, complete the following steps.Notes:1. Do not use the Hardware Wizard to install the drivers. If the Hardware Wizardstarts itself for the installation of any System Management Driver hardware, exitthe Hardware Wizard by selecting Cancel.2. If IBM Netfinity ® Director, IBM Director, or UM Services is running on the server,stop the system-management application before proceeding.Complete the following steps to manually install the Windows 2000 ASM devicedrivers.1. Open a command prompt.2. If you are installing from a diskette, type: A:\WIN2000\SETUP, where A is the driveletter of the diskette drive.3. If you are installing from the IBM Remote Supervisor Adapter Support CD, type:D:\DD\WIN2000\SETUP, where D is the drive letter of the CD-ROM drive.4. Follow the directions that display on the screen.5. Go to “Configuring the remote control password” on page 50.Configuration 47