Table 2. Firmware Checkpoints. (continued)Checkpoint Description Action/ Possible Failing FRUE601 SSA PCI adapter BIST has been startedbut failed to complete after 4 secs.1. Replace the adapter.2. Go to “MAP 1540: MinimumConfiguration” on page 50.E602 SSA PCI adapter open firmware hasstarted.1. Replace the adapter.2. Go to “MAP 1540: MinimumConfiguration” on page 50.E603 SSA PCI adapter BIST has completedwith an error.1. Replace the adapter.2. Go to “MAP 1540: MinimumConfiguration” on page 50.E604 SSA PCI adapter BIST and subsequentPOSTs have completed successfully1. Replace the adapter.2. Go to “MAP 1540: MinimumConfiguration” on page 50.E605 SSA PCI adapter BIST has completedsuccessfully, but the subsequent POSTshave failed.1. Replace the adapter.2. Go to “MAP 1540: MinimumConfiguration” on page 50.E60E SSA PCI adapter open firmware aboutto exit (no stack corruption).1. Replace the adapter.2. Go to “MAP 1540: MinimumConfiguration” on page 50.E60F SSA PCI adapter open firmware has rununsuccessfully.1. Replace the adapter.2. Go to “MAP 1540: MinimumConfiguration” on page 50.E6FF SSA PCI adapter open firmware aboutto exit (with stack corruption)1. Replace the adapter.2. Go to “MAP 1540: MinimumConfiguration” on page 50.Boot Problems/ConcernsDepending on the boot device, a checkpoint may be displayed on the operator panel foran extended period of time while the boot image is retrieved from the device. This isparticularly true for tape and network boot attempts. If booting from CD-ROM or tape,watch for activity on the drive’s LED indicator. A blinking LED indicates that the loadingof either the boot image or additional information required by the operating systembeing booted is still in progress. If the checkpoint is displayed for an extended period oftime and the drive LED is not indicating any activity, there might be a problem loadingthe boot image from the device.Note: For network boot attempts, if the system is not connected to an active network orif the target server is inaccessible (which can also result from incorrect IPparameters being supplied), the system will still attempt to boot. Becausetime-out durations are necessarily long to accommodate retries, the system mayappear to be hung.This procedure assumes that a CD-ROM drive is connected to internal SCSI connectorJ7 and a diagnostics CD-ROM is available.90 Service Guide
