Instructions for IBM Business PartnersIn addition to the instructions in this chapter for installing optional hardwaredevices, updating firmware and device drivers, and completing the installation,IBM Business Partners must also complete the following steps:1. After you have confirmed that the server starts correctly and recognizes thenewly installed devices and that no error LEDs are lit, run the Dynamic SystemAnalysis (DSA) stress test. For information about using DSA, see “IBMDynamic System Analysis” on page 169.2. Shut down and restart the server multiple times to ensure that the server iscorrectly configured and functions correctly with the newly installed devices.3. Save the DSA log as a file and send it to IBM. For information abouttransferring data and logs, see “How to send DSA data to IBM.”4. To ship the server, repackage it in the original undamaged packing materialand observe IBM procedures for shipping.Support information for IBM Business Partners is available at http://www.ibm.com/partnerworld/pwhome.nsf/weblook/index_us.html.How to send DSA data to IBMBefore you send diagnostic data to IBM, read the terms of use athttp://www.ibm.com/de/support/ecurep/terms.html.You can use any of the following methods to send diagnostic data to IBM:v Standard upload: http://www.ibm.com/de/support/ecurep/send_http.htmlv Standard upload with the system serial number: http://www.ecurep.ibm.com/app/upload_hwv Secure upload: http://www.ibm.com/de/support/ecurep/send_http.html#securev Secure upload with the system serial number: https://www.ecurep.ibm.com/app/upload_hw24 System x3750 M4 Types 8722 and 8733: Installation and Service Guide
