v Remote Supervisor Adapter II SlimLine configurationFor information about setting up and cabling a Remote Supervisor Adapter IISlimLine for use in an Advanced System Management (ASM) network, see“Setting up a Remote Supervisor Adapter II SlimLine” on page 67.Using the Configuration/Setup Utility programUse the Configuration/Setup Utility program to perform the following tasks:v View configuration informationv View and change assignments for devices and I/O portsv Set the date and timev Set and change passwords and Remote Control Security settingsv Set the startup characteristics of the server and the order of startup devicesv Set and change settings for advanced hardware featuresv View and clear error logsv Change interrupt request (IRQ) settingsv Resolve configuration conflictsStarting the Configuration/Setup Utility programTo start the Configuration/Setup Utility program, complete the following steps:1. Turn on the server.2. When the prompt Press F1 for Configuration/Setup is displayed, press F1. Ifyou have set both a power-on password and an administrator password, youmust type the administrator password to access the full Configuration/SetupUtility menu. If you do not type the administrator password, a limitedConfiguration/Setup Utility menu is available.3. Select settings to view or change.Configuration/Setup Utility menu choicesThe following choices are on the Configuration/Setup Utility main menu. Dependingon the version of the BIOS code, some menu choices might differ slightly fromthese descriptions.v System SummarySelect this choice to view configuration information, including the amount ofinstalled memory. When you make configuration changes through other choicesin the Configuration/Setup Utility program, the changes are reflected in thesystem summary; you cannot change settings directly in the system summary.This choice is on the full and limited Configuration/Setup Utility menu.– Processor SummarySelect this choice to view the processor information, including the type, speedand cache size of the microprocessor.v System InformationSelect this choice to view information about the server, such as machinetype/model, system serial number, system UUID, system board identifier, and thesystem asset tag. You can also view the version, date, and build level of theBIOS and the ASM Adapter ROM. You cannot change the system informationsettings.This choice is on the full Configuration/Setup Utility menu only.v Devices and I/O Ports42 IBM System x3350 Types 4192 and 4193: User’s Guide