3. Follow the prompts to complete the installation.The installation program prompts you for a TCP/IP port number and an IPaddress. Specify an IP address, if you want to limit the connection requests thatwill be accepted by the utility program. To accept connections from any server,type INADDR_ANY as the IP address. Also specify the port number that the utilityprogram will use. These values will be recorded in the smbridge.cfg file for theautomatic startup of the utility program.Complete the following steps to install the OSA SMBridge management utilityprogram on a server running a Linux operating system. You must be logged in as aroot user to perform these procedures.1. Go to http://www.ibm.com/systems/support/. Download the utility program andcreate the OSA BMC Management Utility CD.2. Insert the OSA BMC Management Utility CD into the drive.3. Type mount/mnt/cdrom.4. Locate the directory where the installation RPM package is located and typecd/mnt/cdrom.5. Type the following command to run the RPM package and start the installation:rpm -ivh osasmbridge-2.0-xx.i386.rpm6. Follow the prompts to complete the installation. When the installation iscomplete, the utility copies files to the following directories:/etc/init.d/SMBridge/etc/smbridge.cfg/usr/sbin/smbridged/var/log/smbridge/var/log/smbridge/LICENSEThe utility starts automatically when the server is started. You can also locate the/etc/init.d directory to start the utility and use the following commands to managethe utility:62 IBM System x3350 Types 4192 and 4193: User’s Guide
