Select this choice to clear the system-event log.v User SecuritySelect this choice to set, change, or clear passwords. See “Passwords” for moreinformation.This choice is on the full and limited Setup utility menu.– Set Power-on PasswordSelect this choice to set or change a power-on password. For moreinformation, see “Power-on password” on page 163.– Clear Power-on PasswordSelect this choice to clear a power-on password. For more information, see“Power-on password” on page 163.– Set Administrator PasswordSelect this choice to set or change an administrator password. Anadministrator password is intended to be used by a system administrator; itlimits access to the full Setup utility menu. If an administrator password isset, the full Setup utility menu is available only if you type the administratorpassword at the password prompt. For more information, see “Administratorpassword” on page 163.– Clear Administrator PasswordSelect this choice to clear an administrator password. For more information,see “Administrator password” on page 163.v Save SettingsSelect this choice to save the changes that you have made in the settings.v Restore SettingsSelect this choice to cancel the changes that you have made in the settings andrestore the previous settings.v Load Default SettingsSelect this choice to cancel the changes that you have made in the settings andrestore the factory settings.v Exit SetupSelect this choice to exit from the Setup utility. If you have not saved thechanges that you have made in the settings, you are asked whether you want tosave the changes or exit without saving them.PasswordsFrom the User Security menu choice, you can set, change, and delete a power-onpassword and an administrator password. The User Security choice is on the fullSetup utility menu only.If you set only a power-on password, you must type the power-on password tocomplete the system startup and to have access to the full Setup utility menu.An administrator password is intended to be used by a system administrator; itlimits access to the full Setup utility menu. If you set only an administratorpassword, you do not have to type a password to complete the system startup, butyou must type the administrator password to access the Setup utility menu.If you set a power-on password for a user and an administrator password for asystem administrator, you must type the power-on password to complete thesystem startup. A system administrator who types the administrator password hasaccess to the full Setup utility menu; the system administrator can give the user162 System x3650 M3 Types 4255, 7945, and 7949: Installation and User’s Guide