Important: Before you install a legacy operating system (such as VMware) on aserver with an LSI SAS controller, you must first complete the following steps:1. Update the device driver for the LSI SAS controller to the latest level.2. In the Setup utility, set Legacy Only as the first option in the boot sequence inthe Boot Manager menu.3. Using the LSI Configuration Utility program, select a boot drive.For detailed information and instructions, go to https://www.ibm.com/systems/support/supportsite.wss/docdisplay?lndocid=MIGR-5083225.Typical operating-system installationThe ServerGuide program can reduce the time it takes to install an operatingsystem. It provides the device drivers that are required for your hardware and forthe operating system that you are installing. This section describes a typicalServerGuide operating-system installation.Note: Features and functions can vary slightly with different versions of theServerGuide program.1. After you have completed the setup process, the operating-system installationprogram starts. (You will need your operating-system CD to complete theinstallation.)2. The ServerGuide program stores information about the server model, serviceprocessor, hard disk drive controllers, and network adapters. Then, theprogram checks the CD for newer device drivers. This information is storedand then passed to the operating-system installation program.3. The ServerGuide program presents operating-system partition options that arebased on your operating-system selection and the installed hard disk drives.4. The ServerGuide program prompts you to insert your operating-system CDand restart the server. At this point, the installation program for the operatingsystem takes control to complete the installation.Installing your operating system without using ServerGuideAbout this taskIf you have already configured the server hardware and you are not using theServerGuide program to install your operating system, complete the followingsteps to download the latest operating-system installation instructions from theIBM Web site.Note: Changes are made periodically to the IBM Web site. The actual proceduremight vary slightly from what is described in this document.1. Go to http://www.ibm.com/systems/support/.2. Under Product support, click System x.3. From the menu on the left side of the page, click System x support search.4. From the Task menu, select Install.5. From the Product family menu, select System x3650 M3.6. From the Operating system menu, select your operating system, and then clickSearch to display the available installation documents.166 System x3650 M3 Types 4255, 7945, and 7949: Installation and User’s Guide