To remove and store the full-length-adapter bracket, complete the following steps:1. Press the bracket tab 3 and slide the bracket to the left until the bracket fallsfree of the riser-card assembly.2. Align the bracket with the storage location on the riser-card assembly asshown.3. Place the two hooks 1 in the two openings 2 in the storage location on theriser-card assembly.4. Press the bracket tab 3 and slide the bracket toward the expansion-slot-opening end of the assembly until the bracket clicks into place.5. Return to “Installing a PCI adapter” or “Installing a PCI riser-card assembly”on page 47, as applicable.Installing a PCI adapterUse this information to install a PCI adapter.About this taskThe following illustration shows the PCI adapter expansion slots from the rear ofthe server.The following notes describe the types of adapters that the server supports andother information that you must consider when you install an adapter:v Locate the documentation that comes with the adapter and follow thoseinstruction in addition to the instructions in this section. If you have to changeswitch settings or jumper settings on the adapter, follow the instructions thatcome with the adapter.v To ensure that a ServeRAID-10i, ServeRAID-10is, or ServeRAID-10M adapterworks correctly in your UEFI-based server, make sure that the adapter firmwareis at the latest level.Figure 38. Full-length-adapter bracket removalFigure 39. PCI adapter expansion slotsChapter 2. Installing optional devices 53
