ResultsAttention: For proper cooling and airflow, replace all air baffles before you turnon the server. Operating the server with any air baffle removed might damageserver components.Installing the full-length-adapter bracketUse this information to install the full-length-adapter bracket.About this taskIf you are installing a full-length adapter in the upper riser-card PCI slot, you mustfirst install the full-length-adapter bracket in the end of the riser-card assembly.To install the full-length-adapter bracket, complete the following steps:Procedure1. Orient the riser-card assembly as shown.2. Remove the full-length-adapter bracket from the storage location.a. Press the bracket tab 3 and slide the bracket toward the end of theriser-card assembly.b. Push the bracket out of the storage location on the riser-card assembly.3. Align the bracket with the end of the riser-card assembly as shown.4. Place the two hooks 1 in the two openings 2 in the end of the riser-cardassembly.5. Press the bracket tab 3 and slide the bracket to the right until it clicks intoplace.6. Return to the adapter-installation instructions.Storing the full-length-adapter bracketUse this information to store the full-length-adapter bracket.About this taskIf you are removing a full-length adapter in the upper riser-card PCI slot and willreplace it with a shorter adapter or no adapter, you must remove thefull-length-adapter bracket from the end of the riser-card assembly and return thebracket to its storage location.Figure 37. Full-length-adapter bracket installationFull-length-adapter bracket installation52 System x3650 M3 Types 4255, 7945, and 7949: Installation and User’s Guide