3. Install the hard disk drive in the hot-swap bay:a. Orient the drive as shown in the illustration.b. Make sure that the tray handle is openc. Align the drive assembly with the guide rails in the bay.d. Gently push the drive assembly into the bay until the drive stops 1.e. Push the tray handle to the closed (locked) position 2f. If the system is turned on, check the hard disk drive status LED to verifythat the hard disk drive is operating correctly.After you install a hard disk drive, the green activity LED flashes as the diskspins up. The amber LED turn off after about 1 minute. If the new drive startsto rebuild, the amber LED flashes slowly and the green activity LED remains litduring the rebuild process. If the amber LED remains lit, see the ProblemDetermination and Service Guide on the IBM Documentation CD for hard diskdrive problem solutions.Note: You might have to reconfigure the disk arrays after you install hard diskdrives. See the RAID documentation on the IBM ServeRAID Support CD forinformation about RAID controllers.ResultsIf you have other devices to install or remove, do so now. Otherwise, go to“Completing the installation” on page 154.Removing a hard disk driveUse this information to remove a hard disk drive.About this taskTo remove a hot-swap hard disk drive, complete the following steps:Procedure1. Read the safety information that begins on page “Safety” on page v,“Installation guidelines” on page 37, and “Handling static-sensitive devices” onpage 40.2. Press up on the release latch at the top of the drive front.3. Move the handle on the drive to the open position (perpendicular to the drive).LatchHandleFigure 48. Hot-swap hard disk drive removal62 System x3650 M3 Types 4255, 7945, and 7949: Installation and User’s Guide
