3-3Installing the Driver4 Click Create Driver Disk, then select the appropriate operatingsystem.5 If you selected Linux, you must also select the architecture:– i386—For Intel 386 or 486 computers– i586—For Pentium I or II computers– i686—For Pentium III, IV, or AMD K-6 computers– Athlon—AMD Athlon computers6 Select the appropriate floppy disk drive letter, then choose theappropriate format. A full format is required only if the disk hasnever been formatted or if it contains bad sectors.7 Insert a floppy disk, then click OK. The system creates thedriver disk.8 Remove and label the driver disk.Now that you have created your driver disk, proceed with theappropriate driver installation procedure.Installing the Windows DriverThis section contains the following procedures:■ Installing the Driver When You Install Windows■ Installing the Driver in an Existing Windows SystemInstalling the Driver When You Install WindowsTo install the driver while also installing the Windows operatingsystem, follow these steps:1 Install and configure the controller and hard disk drives, asdescribed on page 2-2.2 Create the bootable array, as described on page 2-4.3 Create the driver disk, as described on page 3-2. When finished,remove the driver disk.4 Insert the Windows setup CD and restart the computer to beginthe Windows installation.
