3-8Installing the DriverUnixWare and OpenUNIXThis section contains the following procedures:■ Installing the Driver When You Install UnixWare or OpenUNIX■ Installing the Driver in an Existing UnixWare or OpenUNIX SystemNote: Although the driver disk you create for UnixWare andOpenUNIX differ, the installation procedures for theseoperating systems are the same.Installing the Driver When You Install UnixWare or OpenUNIXTo install the driver when installing UnixWare or OpenUNIX:1 Install and configure the controller and hard disk drives, asdescribed on page 2-2.2 Create the bootable array, as described on page 2-4.3 Create the driver disk, as described on page 3-2. When finished,remove the driver disk.4 Insert the Unix installation CD and start the operating systeminstallation.5 When you see the prompt, insert the driver disk, select InstallHBA diskette, and then press F10.The computer loads the driver from the driver disk anddisplays the HBA screen.6 Select Proceed with Installation, then press F10.7 Complete the installation as appropriate.8 When the installation is finished, remove the driver disk andrestart the computer.Installing the Driver in an Existing UnixWare or OpenUNIX SystemTo install the driver in an existing UnixWare or OpenUNIX system:1 Shut down the computer. Install and configure the controllerand hard disk drives, as described in Chapter 2.2 Create the driver disk, as described on page 3-2. When finished,remove the driver disk.3 Turn on the computer, then insert the driver disk.
