3-5Installing the DriverInstalling the Linux ModuleThis section contains the following procedures:■ Installing the Module When You Install Red Hat or SuSE■ Installing the Module in an Existing Linux SystemNote: For the most up-to-date information on ICP’s support ofLinux, visit www.icp-vortex.com.Installing the Module When You Install Red Hat or SuSETo install the module during a fresh install of Red Hat or SuSE:1 Install and configure the controller and hard disk drives, asdescribed on page 2-2.2 Create the bootable array, as described on page 2-4.3 Create the driver disk, as described on page 3-2. When finished,remove the driver disk.4 Insert the first Red Hat or SuSE installation CD.5 Restart the computer.6 When the Red Hat Welcome screen appears, type expert at theBoot: prompt.7 When prompted, insert the driver disk, then select OK.8 Follow the prompts to set up your preferred environment.9 If you are installing other third-party devices, proceed with theinstallation of those devices. Otherwise, select Done.10 Proceed with the Linux installation according to the Red Hat orSuSE instructions.
