IDS X Series User Manual

Also see for X Series: Installer manual Installer manual Training manual Quick start guide Installer manual

IDS X Series User Manual Manual pdf 14 page image

Section: 7IDS X-series LCD Keypad User Manual 700-411-01D Issued August 201014“No Event - ---”.4. Pressing [6] followed by [*] after the event log viewing is already active will reset the menu to themost recent event.5. Each event description will be followed by two numbered fields if further data is applicable todescribe an event. The first number is the partition number within which the event occurred. Thesecond number will either be the zone or user number associated with the event type.Below is an example of how an event will be displayed on the two-line IDS LCD keypad.“02:00 01/01/2010”“Violate 2 23”Translates to: On 1 Jan 2010 at 2AM zone 23 within partition 2 was violated.NOTE:The event log will only show the time and date up to the last power up. For a more detailed listing, pleaseconsult your installer.8. User Codes8.1 Adding, Deleting and Editing User Codes[*] [MASTER CODE] [*] [PROGRAMMABLE OPTION] [*]All IDS Alarm Panels utilise a user-friendly programmable interface that allows the user to add, modify, ordelete user codes. See Table 1 for a summary of programmable options. The programmable interface isaccessed by entering the USER PROGRAMMING MODE.Table 1: User Programming OptionsOptions Summary of Programmable OptionsOption 0 Allows for the addition of new user codes.Option 1 Allows for the editing of a selected user code.Note that the user code properties are not edited, only the user code itself.Option 2 Allows for the deletion of a user code.Option 3 Allows for the adding/editing of the user code slot.Option 4 Allows for the deletion of a user code using the user code slot number.Option 5 Allows for the viewing of the user code slot number for a selected code.There are 128 available user code slots.Option 10 Allows for the editing of the user code properties for a selected user code.This is a bitmapped menu.Option 11 Allows for the allocation of a selected user code to a designated partition(s).This is a bitmapped menu.Option 13 Allows for the editing of the user outputsOption 14 Allows for the user to enable reporting codes.Option 15 Allows for the editing of reporting code modules.Option 30 Allows for the editing of a zone nameOption 40 Allows for the editing of the timeOption 41 Allows for the editing of the date