IDS X Series User Manual

Also see for X Series: Installer manual Installer manual Training manual Quick start guide Installer manual

IDS X Series User Manual Manual pdf 9 page image

Section: 3IDS X-series LCD Keypad User Manual 700-411-01D Issued August 2010 9To provide greater flexibility the panel caters for the programming of four different STAY PROFILES. EachSTAY PROFILE contains a unique combination of STAY, BUZZ and ALARM zones that cater for aparticular STAY ARM requirement.EXAMPLE:PROFILE 1 might be used when the family goes to bed in the evening. In this profile, some interior zonesmay be programmed as alarm zones or buzz zones, whereas PROFILE 2 is utilised while watchingtelevision when all interior zones would be bypassed. (See section 9.1 How to Select a Stay Profile.)3.2.1 How to Stay Arm[#] [USER CODE] (Do not leave premises)1. Select the required STAY PROFILE. (See Section 9.1)2. Ensure that the LCD display reads „Ready to Arm‟ alongside the partition number being armed. Ifnot, check that all protected doors and windows are closed and that all movement has ceased inthe areas covered by motion detectors.3. Press the [#] key.4. Enter a valid [USER CODE]. If an incorrect code is entered, the keypad will give an error beep. Inthe event of an error, press the [#] key and re-enter the [USER CODE].5. DO NOT violate the Entry/Exit zone (normally the front door). If the Entry/Exit zone is violated thesystem will arm in the AWAY mode.6. The LCD Keypad will read „Exit Delay‟, the ARM LED will come on and the keypad buzzer willsound for the duration of the exit delay.7. When the panel arms, any STAY zones will be automatically bypassed. These are displayed onthe LCD display as solid text. Any violated zones will be displayed on the LCD display as flashingtext. To scroll through zones which have been bypassed or violated use the [PANIC] and [MED]keys.8. Ensure that you enter only those areas that are bypassed.3.2.2 Quick Stay Arm - Shortcut Key(Hold down the [5] key for 2 seconds until the keypad buzzer sounds)It is possible to STAY arm by holding down the [5] key until the keypad buzzer sounds. The panel willimmediately arm into stay mode without any exit delay. Holding the [5] key again will toggle between the4 stay profiles.The LCD display will read „Stay Armed‟ and will indicate any zones that have been bypassed. One is ableto scroll through the list of bypassed, as well as violated, zones by using the [PANIC] and [MED] keys.Quick Select Method:Press the [5] key simultaneously with the [PROFILE NUMBER] and release1. Ensure that the Panel is disarmed.2. Press the [#] key to clear any previous entries.3. Press the [5] key and then simultaneously press keys [1], [2], [3], or [4] – depending on the stayprofile you want to choose – then release both keys.4. A beep will sound to indicate successful selection of a profile.5. Program STAY and BUZZ zones for the profile (see sections 9 and 10), and/or ARM the profile(with the [5] key).