IDS X Series User Manual

Also see for X Series: Installer manual Installer manual Training manual Quick start guide Installer manual

IDS X Series User Manual Manual pdf 15 page image

Section: 8IDS X-series LCD Keypad User Manual 700-411-01D Issued August 2010 158.2 How to Enter the User Program Mode1. Ensure that the panel is not armed.2. Hold down the [*] key until the keypad buzzer sounds.3. The LCD display reads „Master Code + *‟. The factory default is [1234]. Should the MASTERUSER CODE be set to six digits it will be [123456] by default.4. Enter the [MASTER USER CODE], followed by the [*] key. A valid entry will be confirmed by along beep. If an invalid MASTER USER CODE was entered, the keypad buzzer will give an errorbeep (3 short beeps).5. The first menu option – „Option Menu‟, „Add User Code‟ is displayed by default.6. Select a programmable option from Table 1. One may use the [PANIC] or [MED] keys to scrollthrough the menu options.7. Confirm the entry by pressing the [*] key. A valid entry is confirmed by a long beep. An invalidentry will be signalled by means of an error beep (3 short beeps). If an error beep occurs, pressthe [#] key to clear all previous entries, and repeat steps 2 – 6.EXAMPLE:To add a new user code, enter User Program Mode by completing steps 2 - 4 as listed above. MenuOption 0 will be displayed on the LCD screen by default. Press the [*] key to confirm your entry. Onceprompted to „Enter a User Code‟, input a [NEW USER CODE] followed by the [*] key. Once the usercode is programmed, enter the next code followed by [*]. To exit the program mode press the [#] key.For a full list of options, refer to Table 1. Programming of these options is explained below.8.3 Explanation of Programmable Options8.3.1 Option 0 - Add a New User Code[*] [MASTER CODE] [*] [0] [*] [NEW CODE] [*] [#]1. Enter the User Program Mode as per steps 1 - 4 of section 8.2.2. The LCD display reads „Option Menu‟, „Add User Code‟. As this is the programmable option yourequire, press the [*] key.3. The LCD display reads „New Code + *‟.4. Enter [NEW USER CODE] followed by the [*] key.5. A valid entry is confirmed by a long beep. An invalid entry will be signalled by means of an errorbeep (3 short beeps). If an error beep occurs, press the [#] key to clear all previous entries andrepeat steps 1-4.6. Further codes can be added by repeating step 4 above. When a user code is added, it is storedin the first available user slot.7. Press the [#] key to exit the User Program Mode.8.3.2 Option 1 - Edit a Selected User Code[*] [MASTER CODE] [*] [1] [*] [OLD CODE] [*] [NEW CODE] [*] [#]1. Enter the User Program Mode as per steps 1 - 4 of section 8.2.2. The LCD display reads „Option Menu‟, „Add User Code‟.