Section: 8IDS X-series LCD Keypad User Manual 700-411-01D Issued August 201018Table 2: User Code PropertiesOption Property1 Master User2 Duress Code3 Arm to Disarm Code [Maid‟s Code]4 Arm Code5 Disarm Code6 Global Arm /Disarm7 Programmable Output CodeExplanation of User Code Properties8.3.7.1 Master UserWhen assigned to a user, this property allows the user to act as a Master User.8.3.7.2 Duress Code This is a special 4 (default) or 6-digit user code (check the code length with your installer) andshould only be used in the unique situation where an intruder forces one to disarm the system"under duress". When the [DURESS CODE] is entered, the control panel disarms normally - however a DURESSREPORTING CODE is transmitted to the monitoring company to inform them that you have beenforced to disarm the control panel by an intruder. It is advisable to choose a code that can be easily remembered by all family (or staff) members.8.3.7.3 Maid‟s CodeThis code can be used to limit access to the premises. A maid‟s code will only disarm the system if thesame code was used for arming. If armed with a code other than this code, the system will view anattempt to disarm using a maid‟s code as an invalid entry. Any valid user code will disarm the system if ithas been armed with a maid‟s code.8.3.7.4 ArmThis code will arm the partitions assigned to the user depending on their status. If all partitions aredisarmed, entering a group code will arm all of the assigned partitions. In a case where some partitionsare armed and others disarmed, entering this group code at the keypad of the disarmed partition will armthe disarmed partitions only.8.3.7.5 DisarmThis code will disarm the partitions assigned to the user depending on their status. If all partitions arearmed, entering a group code will disarm all of the assigned partitions. In a case where some partitions