Icom IC-7100 Instruction Manual

Also see for IC-7100: Finger touch operation Specification Basic Manual Service manual Advanced instructions

Contents

Icom IC-7100 Instruction Manual Manual pdf 153 page image

15 VOICE TX FUNCTION15-2Previous viewThe Voice TX function transmits the recorded audio onan SD card once, or repeatedly, for up to 10 minutes atthe specifi ed interval.Up to 4 memories are available for repeated CQ andexchange transmissions in contests, as well as whenmaking repeated calls to DX’peditions.The recorded audio can be transmitted in the SSB, AM(HF/50 MHz only), FM or DV mode.The Voice TX function can be assigned to a key on theoptional HM-151 REMOTE CONTROL MIC or an externalkeypad. (p. ??-??)NOTE: Be sure to insert an SD card into the trans-ceiver before recording a voice audio.Pushq MENU (C) one or more times to select the “M-2” (Menu 2) screen.• In the DR mode, select the “D1” screen.Touch [VOICE](w D) to select the Voice TX mode.• The “VOICE TX” screen is displayed.Pushe MENU (C) to display the “VOICE” screen.Touch [REC](r D) to display the “VOICE TX RECORD”screen.Touch the desired memory, [T1] through [T4].t• The “VOICE TX RECORD (T1)” screen is displayed,when [T1] memory is selected.Touch [y ●](D) to start recording.• Touch [■](D) to cancel recording.• The maximum record time is 90 seconds.• Hold the microphone 5 to 10 cm (2 to 4 inches) from yourmouth, then speak at a normal voice level.• Touch [MIC GAIN](D) to display the “MIC GAIN” screen.• If you record again on the same channel, the current con-tents will be overwritten.Touch [u ](C) to return to the “VOICE TX RECORD”screen.Information✓To delete the recorded au-dio, touch the center of the“VOICE TX RECORD (T1)”through “VOICE TX RECORD(T4)” screen for 1 second, orpush QUICK (C), and thentouch “Clear.”Recording the voice audioTouch[VOICE]Touch [REC](Example)Touch [T1]Push MENUTouch [●]The “MIC GAIN”screen appearsafter touchingShows the audio input level.While recordingAdjust so theREC level bardoes not reachthis level.The L, R, C or D in theinstructions indicate thepart of the controller.L: Left sideR: Right sideC: Center bottomD: Display (Touch panel)Left RightCenterDisplay