Icom IC-7100 Instruction Manual

Also see for IC-7100: Finger touch operation Specification Basic Manual Service manual Advanced instructions

Contents

Icom IC-7100 Instruction Manual Manual pdf 19 page image

4 RECEIVE AND TRANSMIT4-3Previous viewOperating CWSelect the desired frequency band. (p. 35)qOn the Mode selection screen, touch “CW” to selectwthe CW mode.• After the CW mode is selected, touch “CW” again to tog-gle between CW and CW-R modes, if necessary.Rotate the Dial to tune a desired signal.e• The S-meter displays the received signal strength.• The tuning step can be changed on the Tuning step se-lection screen by touching “kHz frequency.” (p. 38)Rotate [AF]r (L) to adjust the audio to a comfort-able listening level.Set the Break-in operation to the semi break-in or fulltbreak-in mode.• “BKIN,” “F-BKIN” or “OFF (no indication)” appears.While the “M-3” menu is selected, touch [BK-IN](D)once or twice to select the Break-in operation.• BKIN : Semi break-in• F-BKIN : Full break-in• OFF : No break-in (ACC socket connection for TXis necessary, as shown on page 22.)If a microphone is connected, its PTT can beused instead of the external TX switch.If the Semi break-in operation is selected at stepy t,set the Break-in delay.q While the “M-3” menu is selected, touch[BK-IN](D) for 1 second to open the Break-indelay adjustment window.w Rotate the Dial to adjust the delay time.• The adjustable delay time is between 2.0 and 13.0dots.Use the electric keyer or paddle to key your CW sig-unals.• The TX/RX indicator lights red.• The Po meter indicates transmitted CW output power.If desired, adjust the Key speed or CW pitch.iq Push SPEED/PITCH (C) to open the Key speed/CWpitch adjustment window.w Rotate [M-CH] (L) to adjust the Key speed, or[BANK] (L) to the CW pitch.• The adjustable key speed is between 6 and 48 wpm(words per minute).• The adjustable CW pitch is between 300 and 900Hz.e Push MENU (C) to close the window.Stop keying to return to receive.oConvenient Receive functions• Preamp and attenuator (p. 71)• Twin PBT (passband tuning) (p. 75)• AGC (auto gain control) (p. 72)• Noise blanker (p. 76)• Noise reduction (p. 77)• Manual Notch fi lter (p. 77)• ¼ function (p. 39)• CW pitch control (p. 49)Convenient Transmit functions• Break-in function (p. 79)• Keying speed setting (p. 49)• Memory keyer (p. 50)The L, R, C or D in theinstructions indicate thepart of the controller.L: Left sideR: Right sideC: Center bottomD: Display (Touch panel)Left RightCenterDisplay“CW” or “CW-R” appearsSemi break-in operation is selectedAppears