Icom IC-7100 Instruction Manual

Also see for IC-7100: Finger touch operation Specification Basic Manual Service manual Advanced instructions

Contents

Icom IC-7100 Instruction Manual Manual pdf 157 page image

15 VOICE TX FUNCTION15-6Previous viewPushq MENU (C) one or more times to select the “M-2” (Menu 2) screen.• In the DR mode, select the “D1” screen.Touch [VOICE](w D) to select the Voice TX mode.• “VOICE TX” screen is displayed.Pushe MENU (C) to display the “VOICE” screen.r <>Touch the desired memory, [T1] through [T4] totransmit the recorded voice audio once.<>Touch the desired memory, [T1] through [T4] for 1second to repeatedly transmit the recorded voiceaudio for up to 10 minutes at the interval specified in“Repeat Time.”• Even if 10 minutes pass while transmitting, the voice au-dio is completely transmitted.• During the Voice TX waiting, the selected memoryblinks.• One of the following steps will cancel the transmission.- Touch the memory again.- Turn OFF the power, then turn it ON again.- Touch another memory (except for [LEVEL]).- Push MENU (C), XFC (R) or SET (C).- Push QUICK (C).The repeat transmission is cancelled. But while trans-mitting, the voice audio is completely transmitted.• Once the Repeat TX is made, the transceiver pausesuntil the end of the “Repeat Time,” then transmits again.After the second transmission, the Repeat TX continuespausing, if receiving a signal.But if the squelch is manually opened, the voice audio isrepeatedly transmitted, according to the repeat time set-ting.• Voice TX Waiting screen for <>Transmitting the recorded voice audioBlinks whiletransmittingTouch[VOICE]Touch thedesiredmemory,Single TXRepeat TXBlinksThe L, R, C or D in theinstructions indicate thepart of the controller.L: Left sideR: Right sideC: Center bottomD: Display (Touch panel)Left RightCenterDisplay