Icom IC-G80 Instruction Manual

Icom IC-G80 Instruction Manual Manual pdf 28 page image

236 SCAN OPERATION■ Scan resume settingWhen a signal is received during a scan, the scan resumesetting determines what action the transceiver takes. Thetransceiver has two scan resume settings, as describedbelow. Use the Set mode to select the one which best suitsyour needs.q Push [FUNC](M), and then [SET](8) to enter the Set mode.wPush [] or [] to select the scan pause timer item (SCt,or SCP).eRotate [VOL] to select a scan pause option.• Pause scanThe scan pauses until the received signal disappears,and then resumes after 2 seconds.• Timer scanThe scan pauses for 5 seconds, 10 seconds or 15 sec-onds, and then resumes.r Push [# ENT](MN.W) to exit the Set mode.■ Priority watchThe priority watch checks for signals on the selected chan-nel (Priority channel) every 5 seconds.The priority channel is pre-programmed by your dealer, andyou cannot change the setting with the transceiver. Ask yourdealer for details.q Push [FUNC](M), and then [PRIO](7) to start the watch.• The decimal point “ . ” on the alphanumeric display blinks.• When a signal is detected on the channel, the watch pauses,and then resumes according to the scan resume setting. (p. 32)w To cancel the watch, push any key except [ ], []/[],[FUNC], [ ] or [MONI].NOTE: When you start the priority watch, the Tone func-tion and the output power are automatically returned tothe setting or level pre-programmed by your dealer.[VOL] Pause scanTimer scan (15 seconds)Operating channel Priority channel5 seconds