Icom IC-V8 Instruction Manual

Also see for IC-V8: Instruction manual Instruction manual Service manual Service manual

4611OTHER FUNCTIONS‘‘ Set modeDD Set mode enteringq Push [8•SET] after [A•FUNC] is pushed.w Push [∫] or [√] to select item.e Rotate [VOL] to select condition/value.• To exit set mode, push [#•ENT ].DD Repeater tone frequencySelects tone encoder frequency for accessinga repeater, etc. from one of 50 available fre-quencies.• 67.0–254.1 Hz (50 tones): 88.5 Hz (default)DD Tone squelch frequencySelects frequency for tone squelch or pocketbeep operation from one of 50 available fre-quencies.• 67.0–254.1 Hz (50 tones): 88.5 Hz (default)DD DTCS codeSelects DTCS encoder/decoder code with po-larity (N: normal/I: inverse) from one of 208available codes.• 023N/I–754N/I: 023N (default)DD Offset frequencySets the offset frequency for duplex (repeater)operation within 0–20.00 MHz range.DD Reverse functionTurns the reverse function ON and OFF.• Default: OFFMRF TXMRF TXMRF D TXMRF TXMRF TX4510 PAGER/CODE SQUELCH‘‘ Code squelchCode squelch provides communications with quiet standby sinceyou will only receive calls from stations which know your ID orgroup code. Each push of [PTT] sends a 3-digit code in order toopen the receiving station’s code squelch prior to voice transmis-sion.q Set the operating frequency.• Set the AF and squelch to the desired level as the normal operation.w Push [✱•OPTION] after [A•FUNC] is pushed.• Repeat several times, if necessary.• Code squelch mode is selected.• 100 MHz digit shows “C.”e Select the desired transmit code channel:➥ Push [8•SET] after [A•FUNC] is pushed.➥ Rotate [VOL] to select the desired code channel.➥ Push [#•ENT ] to exit code set mode.r Operate the transceiver in the normal way (push [PTT] to trans-mit; release [PTT] to receive).t To cancel the code squelch, push [✱•OPTION] after [A•FUNC] ispushed.• 100 MHz digit shows “1” when the function is cancelled.Optional UT-108 requiredMRF TX